Conductive parts manufacturers: what are the common and easy-to-use terminals

Taizhou Tongren Electric Co., Ltd. (a manufacturer of conductive parts) was established in 2008. It is a private enterprise that produces and sells switches, electronic components, and electrical accessories. The company specializes in the production of all kinds of electrical conductive parts, solid-sealed outlets, contact arms and other electrical accessories. As a professional manufacturer of conductive parts, Tongren Electrical Appliances takes quality as its lifeblood and maintains a good cooperative relationship with major domestic electrical appliances companies. From material selection, manufacturing, and out of warehouse, it follows strict management standards and meets customer demands. . The company's credibility and reputation have been highly praised by industry peers. The company is currently in the development stage, constantly pursuing progress in technology, and constantly supplementing resources to meet the needs of production. The company respects science and pursues excellence, and actively introduces new technologies and new technologies to promote the upgrading of the company's industrial structure.

Usually we may have seen, inflatable cabinets, switch cabinets, you may not know which small accessories are used in them. Below, Tongren Electric will introduce to you which terminals are available.

1. Parallel buckle, put two flexible wires inside, clamp it with pliers, it may not be strong with pliers, check after clamping;

2. Push-type butt-connecting terminal, there are screw presses, it is very convenient to use this to connect the light;

3. Parallel, wire parallel, thread hinge;

4. Tubular-type pre-insulated cold-pressed terminal, set the cord end of the flexible wire, flatten it with a pliers, and the wire will become hard. Some of the wire ends need to be tinned and hardened. You can use this directly to connect to the air circuit breaker or the socket. It is also softer. It is safer to go in loosely;

5. There are many kinds of copper noses, u-shaped and y-shaped, copper pipes for high-power and large-diameter wires, and cold-pressed thin wires. Most of the purpose is to fix the wires with screws. The u-shaped is open, which saves trouble, and the o-shaped safer;

6. The neutral line is connected to the ground wire in the electric box.

7. Spiral wire cap, rotating wire cap, wiring cap, after the two thread ends are screwed together, put on this turn, the more screwed, the tighter, no need to press, it is safer to set a heat shrinkable tube after screwing

8. Plug-in spring plug-in terminal. The front foot presses the thread core, the rear foot presses the thread skin, and the lock plug spring needs to be pressed in the middle when pulling out. The picture shows the L-shaped lock plug spring

9. Fence type terminal block, there are double rows, high and low rows

10. Spring terminal block. This picture needs to be soldered to the board, usually with pre-insulated terminals